LED lamps are energy-saving, high-brightness, long-life, and low failure rate. They have become a kind of luminous body that ordinary household users like. However, a low failure rate does not mean that there is no failure. What should we do when the LED street lamp head fails-replace the lamp? Too extravagant! In fact, the cost of repairing LED lights is very low, the technical difficulty is not high, and ordinary people can operate it.

The lamp bead is damaged

After the LED lamp is turned on, some of the lamp beads do not light up, basically it can be judged that the lamp beads are damaged. The damaged lamp bead can generally be seen with the naked eye-there is a black spot on the surface of the lamp bead, which proves that it has been burned. Sometimes the lamp beads are connected in series and then in parallel, so the loss of a certain lamp bead will cause a lamp bead to not light up. We provide two maintenance solutions based on the number of damaged lamp beads.

1. A small amount of damage

If only one or two lamp beads are broken, we can repair them by these two methods:

1. Find the broken lamp bead, connect the metal at both ends of it with a wire, and short-circuit it. The effect of this is that most of the lamp beads can light up normally, and only the broken individual lamp beads do not light up, which has little effect on the overall brightness.

2. If you have strong hands-on ability, you can go online to buy the same model of lamp beads (a large bag of ten dollars), and replace it yourself-use an electric soldering iron (a hair dryer to blow on for a while) to heat the old lamp beads , Until the glue on the back of the old lamp bead has melted, remove the old lamp bead with tweezers (don’t use your hands, it’s too hot). At the same time, install the new lamp beads while it is hot (pay attention to the positive and negative poles), and you're done!

Second, a large amount of damage

If a large number of lamp beads are damaged, it is recommended to replace the entire lamp bead board. The lamp bead board is also available online, please pay attention to three points when buying:

1. Measure the size of your own lamps;

2. Be optimistic about the appearance of the lamp bead board and the starter connector (explained later);

3. Make a note of the output power range of the starter (explained later).

These three points of the new lamp bead board must be the same as the old lamp bead board-replacing the lamp bead board is very simple. The new lamp bead board is fixed with magnets. When replacing it, remove the new lamp bead board and connect it to the connector of the starter.

Damaged starter

Most of the LED lamp failures are caused by the starter-if the lamp does not turn on at all, or the lamp flickers after it is turned on, the starter is probably broken.

The starter cannot be repaired, so it can only be replaced with a new one. Fortunately, the new starter is not expensive. Pay attention to three points when buying a new launcher:

1. Pay attention to the appearance of the connector-the starter connector looks as follows (if the starter is male, the lamp bead board is female; vice versa)

2. Make a note of whether your lamp can change color and several colors. The number of discolorations of the new starter must be the same as the old starter.

3. Make a note of the output power range of the starter-a range will be marked on the starter, as long as the power of the lamp bead board is within this range

The replacement is still very simple, first separate the starter from the lamp bead plate, the starter is also fixed on the base with screws, and you can remove it. The new starter is also a magnet, so it can be sucked and connected to the lamp bead board.